Y-006

Product Code: 007

Product model: 918-KOB type (new multifunctional cable stripping machine)

Detailed name: New multifunctional cable stripping machine

Function: This machine is a small multifunctional straight strip stripping machine, which can strip almost all types and models of wires and cables below 42mm at home and abroad. Loose twisted wires, single wires, electronic wires, closed-circuit cables, network cables, armored cables, high-voltage insulated cables, etc. can all be easily peeled off, greatly improving the efficiency of plastic copper separation work.

This machine is a straight belt with dual blade and dual rolling design. The motor is produced by a Shanghai company and meets the national standard of 2.2KW. It has strong power (with a one-year replacement of the motor). The dual blade design allows users to no longer worry about the insulation layer becoming hard and difficult to peel off under low temperature conditions. The machine has 21 wire entry holes, including 4 smooth cutting holes, 2 single wire rolling separation holes, 2 flat wire holes, 3 twin holes, and 10 circular holes (5 double blade feeding holes), with a wide range of options. Add machine bottom shaft adjustment bolts to improve the peeling effect.


Operating instructions:

1. Start the motor and check if it is running normally. When feeding, check the diameter of the rubber cables wrapped around each gear and feed them one by one.
2. In order to make the blade durable for a long time, the joint of the rubber cable should be cut off when feeding to prevent the blade from breaking due to a notch.
3. If there is excessive depth and wire breakage after the feed is discharged, pay attention to the following situations:

① Adjust the tightness of the M12 screws on both sides of the blade shaft on the feeding gear;
② Check if the position is placed incorrectly during feeding;
③ Check if the blade has been replaced and if the edge is too sharp. Use a specialized oilstone to slightly trim it until it is moderately adjusted.
4. If the rubber has been peeled off after feeding, but the copper wire cannot be ejected.

There are four main situations:

① If the rolling pattern on the upper shaft is too deep, a special oilstone should be used to grind the upper shaft, but excessive grinding is not allowed. Excessive grinding can easily cause oily cables to be difficult to transmit;
② Is the spring pressure too loose? The pressure should be tightened and stopped as soon as it can be released;
③ If the diameter of the wire is too small or the gap between the upper and lower shafts is too large, the gap between the two shafts should be adjusted to 0  4---0 .  6mm ;
④ The processed rubber cable has already heated up, and the copper wire cannot be ejected.
5. If the pressure gear cannot drive the cable through after feeding and the material stays in the middle, there are several situations that may occur:
① Check if there is any looseness in the belts of each gear;
② Check if the spring pressure on both sides of each gear is too tight and there is no pushing force. The pressure should be relaxed;
③ The cable is too oily, causing the two shafts to slip. The two shafts should be wiped dry regularly (when wiping, please pay attention to safety if the machine is running).